American Dynamics SpeedDome Ultra 8 Operator's Manual page 80

4. The Select Name to Program screen appears.
5. Press Zoom to change the number. When the item whose name you want to change
appears press Focus Far.
6. The Name Programming screen appears.
7. Move the blinking highlight around the available characters. When the correct character is
highlighted, press Focus to select it.
If you make a mistake, Zoom In moves the cursor one space right, and Zoom Out moves
the cursor one space left in the name.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Figure 66. Select Name to Program screen
SELECT NAME TO PROGRAM
NUMBER
1
FOCUS FAR to program names
Note: If Presets, Patterns, or Areas have been programmed, the dome
automatically points to the starting position of the associated selection each time
the number is advanced.
Figure 67. Example Name Programming Screen
NAME PROGRAMMING
NAME: ALARM 1
ABCDEFGHIJKLMNOPQRST
UVWXYZabcdefghijklmn
opqrstuvwxyz 0123456
789/-
UNDO CHANGES AND QUIT
78 of 140
CURRENT NAME
EXIT
EXIT
Blank Space
character
8200-0600-01, REV. B