Area Boundaries - American Dynamics SpeedDome Ultra 8 Operator's Manual

To program areas, select Area Boundaries from the Alarms/Areas/Home/Presets/PZ
screen. The following screen appears:
If no boundary is set, pressing Focus quits without making any changes.
The dome supports from 2 to 16 areas.
Setting Area Boundaries
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Move the highlight bar to Area Boundaries, then select.
The Area Boundaries screen appears.
3. Adjust the camera to the starting point of the first area, and press Zoom to mark the
boundary.
4. Adjust the dome to the right until the ending point of the area is seen. If you attempt to
move left, an error message appears. See the note on page
5. Mark the end-point of the area.
The area number automatically advances.
6. Repeat steps 4 and 5 for each area you want to establish.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Figure 34. Area Boundaries screen

AREA BOUNDARIES

PAN to START OF BOUND
ZOOM to mark BOUNDARY
FOCUS quits w/o changing
I M P O R T A N T
If areas were previously programmed, you cannot restore the previously
programmed boundaries by selecting Quit Without Saving from the Dome
Configuration Menu once you begin making changes to the boundaries.
48 of 140
PAN RIGHT ONLY
1
4 9 for information.
2
8200-0600-01, REV. B