Working With The Dome Configuration Utility; Entering The Dome's Password - American Dynamics SpeedDome Ultra VII RAS917LS Configuration

Working with the Dome Configuration Utility

Once the Dome Configuration Menu is displayed, you may select a menu item, and then modify the
settings you want to change. The following table summarizes the controller commands for SensorNet,
RS-422, and Manchester protocols. For combination keystrokes, press and hold each button in
sequence, then release.
If you want to ...
Move the highlight bar.
Select the highlighted item on the screen.
Increase the value of the selected setting or display the next
choice for the setting
Decrease the value of the selected field, or display the
previous choice for the field.
During naming, move the cursor to the right of the current
character in the name.
During naming, move the cursor to the left of the current
character in the name.
Save changes and exit the utility from any screen.

Entering the Dome's Password

A dome password can be used to prevent unauthorized users from starting the configuration utility. If
password protection is enabled the Enter Password screen appears when the command to start the
configuration utility is entered.
Users must enter the password before the Dome Configuration Menu displays. The password may be
from 1 to 8 characters long.
Using the Dome Configuration Utility
ENTER PASSWORD
PASSWORD: ********
A B C D E F G H I J K L M N O P Q R S T
U V W X Y Z a b c d e f g h i j k l m n
o p q r s t u v w x y z
7 8 9 / -
CONTINUE
Use ...
Pan/Tilt
Focus
Zoom In
Zoom Out
Zoom In
Zoom Out
Iris Close, then Focus
0 1 2 3 4 5 6
CANCEL
Blank Space
Character
1–3