Operating The Dome Configuration Menu - American Dynamics SpeedDome Ultra 8 Operator's Manual

If you want to ...
Repeat Pattern 1-3
Set Pattern to Peel
Vphase Dome
Note: The A/I LED blinks indicating that you are in the
vphase mode. Enter key sequence again to turn vphase
adjustment off. The A/I LED stops blinking and indicates
Auto Iris State.
Start Dome Configuration Menu

Operating the Dome Configuration Menu

See
page 122.
Turn IR Mode On
Turn IR Mode Off
Reset Dome
Auto Pan Left Limit
Setting Left and Right Auto Pan Scan Limits
See
page 123.
Auto Pan Right Limit
Setting Left and Right Auto Pan Scan Limits
See
page 123.
Auto Pan ON/OFF
(LED indicates Auto Pan state: ON = Auto Pan is running.)
Operating the Dome Configuration Menu
The following table lists the commands to operate the configuration utility when the dome is
installed in a Vicon environment.
If you want to ...
Start the configuration utility.
Move the highlight bar on the active menu.
Select the highlighted item on the active menu.
Increase the value of the selected setting.
For example, Red or Blue white balance values.
Decrease the value of the selected field.
For example, Red or Blue white balance values.
Display the next choice for the setting. For example,
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
on
on
on
122 of 140
Use ...
Run/Pgm switch to RUN
Enter 83-85 Enter
Enter 89 Enter
Run/Pgm switch to PGM
Enter 93 Enter
•
Pan Right to increment
•
Pan Left to decrement
Enter 94 Enter
Run/Pgm switch to PGM
Enter 95 Enter
Run/Pgm switch to PGM
Enter 96 Enter
Run/Pgm switch to PGM
Enter 97 Enter
Run/Pgm switch to PGM
Enter 98 Enter
Run/Pgm switch to PGM
Enter 99 Enter
Run/Pgm switch to RUN
A/P toggles state
Use ...
Run/Pgm switch to PGM
Enter 94 Enter
Tilt Up/Down
A/P or AUX5
Pan Right (or Zoom In)
Pan Left (or Zoom Out)
Pan Right (or Zoom In)
8200-0600-01, REV. B