American Dynamics SpeedDome Ultra 8 Operator's Manual page 115

5. Use the joystick to move the highlight to Presets. Press Set to select. The Select Preset
to Program screen appears.
6. Use the joystick to select the Preset you want to program. If the Preset has been
programmed the dome automatically moves to that position.
•
•
When the correct Preset number appears, press Set to begin programming.
7. The Presets screen appears. Use the joystick to adjust the dome to the correct pan/tilt
position.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Figure 89. Alarms / Areas / Home / Presets / PTZ screen
ALARMS/AREAS/HOME/PRESETS/PZ
Figure 90. Select Preset To Program screen
SELECT PRESET TO PROGRAM
PRESET
NUMBER
FOCUS FAR to program preset
Move the joystick right to increase the preset number.
Move the joystick left to decrease the preset number.
SET ALARM ACTIONS
SET ALARM STATES
SET HOME POSITION
SET NORTH POSITION
AREA BOUNDARIES
PRIVACY ZONES
PRESETS
SCAN LIMITS
EXIT
PRESET NAME
1 PRESET
SEQUENCE SETUP MENU
CAMERA FUNCTIONS
EXIT
113 of 140
1
8200-0600-01, REV. B