Changing Camera Functions Within Presets - American Dynamics SpeedDome Ultra 8 Operator's Manual

Camera dome, configuration utility version 1.01
Hide thumbs Also See for SpeedDome Ultra 8:
Table of Contents

Advertisement

2. Highlight a desired Pattern number (1-16). Press Focus Far to continue.
3. Pan/tilt/zoom the dome as desired for the Pattern.
4. Execute the keyboard's Pattern save command to save the Pattern.
Running 16 Patterns
When a dome is configured for 16 Patterns, running a Pattern requires displaying the Pattern
Select screen (Figure 49). Follow the steps below to run a Pattern.
1. Enter the appropriate keyboard command to run Patterns 1, 2, or 3. The Pattern Select
screen appears.
2. Highlight the desired Pattern number (1-16) to run.
3. Press Focus Far to select. The Pattern Select screen disappears and the Pattern runs.

Changing Camera Functions within Presets

When Presets are created, they adopt the dome parameters defined in the Camera Functions
screen. You can now customize camera functions for each Preset by accessing the Camera
Functions screen from the Presets screen.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Figure 49. Pattern Select screen
PATTERN SELECT
1
2
3
4
FOCUS FAR TO CONTINUE
Note:
If the controller being used supports the use of 16 Patterns, the 16 Pattern
Feature will execute patterns 1–16 automatically.
61 of 140
5
9
13
6
10
14
7
11
15
8
12
16
8200-0600-01, REV. B

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents