Area Boundaries; Privacy Zones - American Dynamics SpeedDome Ultra 8 Quick Reference Manual

Area Boundaries

4.
AREA BOUNDARIES
5
PAN to START OF BOUND
PAN RIGHT ONLY
ZOOM to mark BOUNDARY
FOCUS quits w/o changing
Up to 16 areas may be programmed. These areas are
separate from areas that may be available through your
switcher.

Privacy Zones

4.
PRIVACY ZONES
6
ADD PRIVACY ZONE
DELETE SPECIFIC ZONES
DELETE ALL ZONES
HIDE ALL ZONES NO
In addition to hiding all programmed privacy zones, this
screen provides links to lower level screens. See the
following screens:
•
Add Privacy Zones (Screen 4.6a)
•
Delete Privacy Zone (Screen 4.6b)
•
Delete All Zones (Screen 4.6c)
Add Privacy Zones
4.
6a
NEW PRIVACY ZONE
Navigate
ZOOM to mark corner
FOCUS to abandon zone
SPEEDDOME ULTRA 8 CAMERA DOME CONFIGURATION UTILITY
QUICK REFERENCE GUIDE
1
EXIT
corner 1
4 of 11
•
Up to 8 Privacy Zones may be programmed.
•
Three points must be selected to establish the
Privacy Zone. The fourth point is automatically
calculated.
•
Use the Pan/Tilt control to position the arrows over
the selection point. If arrows blink, this is not a valid
selection area.
•
Press Zoom to save the point.
Delete Privacy Zone
4.
6b
Navigate
ZOOM to delete zone
FOCUS quits w/o changing
•
Arrows must be clearly positioned in zone to delete.
•
Use the Pan/Tilt control to position the arrows over
the zone. If arrows blink, this is not a valid selection
area.
•
Press Zoom to delete the selected zone.
Delete All Zones
4.
6c
YOU ARE ABOUT TO DELETE
ALL PRIVACY ZONES
This option permanently removes all programmed
Privacy Zones. To temporarily hide the zones, use Hide
All Zones. See Privacy Zones (Screen 4.6).
to zone
CANCEL
CONTINUE
8200-0600-02, REV. B