Rtsi Connector Pinout; Usb Device Led Patterns - National Instruments DAQ X Series User Manual

1
4.

RTSI Connector Pinout

(NI PCIe-632x/634x/635x/636x Devices)
section of Chapter 9,
information about the RTSI connector on PCI Express X Series devices.

USB Device LED Patterns

(NI USB-634x/635x/636x Devices)
ACTIVE and READY. The ACTIVE LED indicates activity over the bus.
The READY LED indicates whether or not the device is configured.
Table 3-2 shows the behavior of the LEDs.
ACTIVE READY
LED LED
Off Off
Off On
On On
Blinking On
© National Instruments
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1
Device Disk Drive Power Connector
Figure 3-1. Connecting to the Disk Drive Power Connector
Replace the computer cover, and plug in and power on the computer.
Digital Routing and Clock
X Series USB devices have LEDs labeled
Table 3-2. LED Patterns
USB Device State
The device is not powered or not connected to the host
computer, or the host computer does not have the correct
version of NI-DAQmx. Refer to Table 2-1,
NI-DAQmx Software Support, for the NI-DAQmx support
information for your device.
The device is configured, but there is no activity over the bus.
The device is configured and there is activity over the bus.
3-5
Chapter 3 Connector and LED Information
2
PC Disk Drive Power Connector
2
Refer to the RTSI Connector Pinout
Generation, for
X Series
X Series User Manual