Custom Cabling And Connectivity; Usb Device Mounting Accessories, Usb Cable, Power Supply, And Ferrite - National Instruments DAQ X Series User Manual

Custom Cabling and Connectivity

The CA-1000 is a configurable enclosure that gives user-defined
connectivity and flexibility through customized panelettes. Visit
for more information about the CA-1000.
NI offers cables and accessories for many applications. However, if you
want to develop your own cable, adhere to the following guidelines for best
results:
•
•
•
For more information about the connectors used for DAQ devices, refer to
the KnowledgeBase document, Specifications and Manufacturers for
Board Mating Connectors, by going to
Info Code
USB Device Mounting Accessories, USB Cable,
Power Supply, and Ferrite
NI offers a variety of products to use with USB Mass Termination X Series
devices, as follows:
•
•
•
•
•
© National Instruments
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
For AI signals, use shielded, twisted-pair wires for each AI pair of
differential inputs. Connect the shield for each signal pair to the ground
reference at the source.
Route the analog lines separately from the digital lines.
When using a cable shield, use separate shields for the analog and
digital sections of the cable. Failure to do so results in noise coupling
into the analog signals from transient digital signals.
.
rdspmb
USB X Series mounting kit—Part number 781514-01
USB X Series mounting kit with DIN rail clip—Part
number 781515-01
USB cable with locking screw, 2 m—Part number 780534-01
Universal power supply with mini-combicon connector,
12 VDC, 2.5 A—Part number 781513-01
EMI suppression ferrites, 10.2 mm length—Part number 781233-02
2-7
Chapter 2 DAQ System Overview
ni.com
and entering the
ni.com/info
X Series User Manual