Using A Digital Source; Using An Analog Source; Routing Do Pause Trigger Signal To An Output Terminal - National Instruments DAQ X Series User Manual

Chapter 6 Digital I/O

Using a Digital Source

To use DO Pause Trigger, specify a source and a polarity. The source can
be one of the following signals:
•
•
•
•
•
•
•
•
•
The source also can be one of several other internal signals on your DAQ
device. Refer to Device Routing in MAX in the NI-DAQmx Help or the
LabVIEW Help for more information.
You also can specify whether the samples are paused when DO Pause
Trigger is at a logic high or low level.

Using an Analog Source

When you use an analog trigger source, the samples are paused when the
Analog Comparison Event signal is at a high level. Refer to the
with an Analog Source
information.
Routing DO Pause Trigger Signal to an Output
Terminal
You can route DO Pause Trigger out to any RTSI <0..7>, PFI <0..15>, or
PXIe-DSTARC terminal.
X Series User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PFI <0..15>
RTSI <0..7>
PXI_STAR
PXIe-DSTAR<A,B>
Counter n Internal Output
Counter n Gate
AI Pause Trigger (ai/PauseTrigger)
AO Pause Trigger (ao/PauseTrigger)
DI Pause Trigger (di/PauseTrigger)
section of Chapter 11, Triggering, for more
6-22
Triggering
ni.com