Usb Device Leds; Usb Cable Strain Relief - National Instruments DAQ X Series User Manual

3.
4.

USB Device LEDs

(NI USB-634x/635x/636x Devices)
section of Chapter 3,
about the X Series USB device READY and ACTIVE LEDs.

USB Cable Strain Relief

(NI USB-634x/635x/636x Devices)
cable by using the jackscrew on the locking USB cable (included in the
X Series USB device kit) to securely attach the cable to the device, as
shown in Figure 1-6.
2
1
1 Locking USB Cable Jackscrew
© National Instruments
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Place the USB X Series device on the backpanel wall mount with the
signal wires facing down and the device bottom sitting on the
backpanel wall mount lip.
While holding the USB X Series device in place, attach the front bracket
to the backpanel wall mount by tightening the two thumbscrews.
Refer to the
Connector and LED
You can provide strain relief for the USB
3
2 Jackscrew Hole
Figure 1-6. USB Cable Strain Relief on X Series USB Devices
1-7
Chapter 1 Getting Started
USB Device LED Patterns
Information, for information
3 Security Cable Slot
X Series User Manual