Mounting X Series Usb Devices; Panel/Wall Mounting - National Instruments DAQ X Series User Manual

Mounting X Series USB Devices

(NI USB-634x/635x/636x Devices)
a desktop, mount it to a wall or panel as described in the Panel/Wall
Mounting section, or mount it to a standard DIN rail as described in the
Rail Mounting

Panel/Wall Mounting

Complete the following steps to mount your USB X Series device to a wall
or panel using the USB X Series mounting kit (part number 781514-01 not
included in your X Series USB device kit). Refer to Figure 1-3.
1.
2.
3.
© National Instruments
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
You can use your X Series USB device on
section.
Use three #8-32 flathead screws to attach the backpanel wall mount to
the panel/wall. Tighten the screws with a #2 Phillips screwdriver to a
torque of 1.1 N · m (10 lb · in.).
Figure 1-3. Using the USB X Series Mounting Kit on a Wall or Panel
Place the USB X Series device on the backpanel wall mount with the
signal wires facing down and the device bottom sitting on the
backpanel wall mount lip.
While holding the USB X Series device in place, attach the
front bracket to the backpanel wall mount by tightening the
two thumbscrews.
1-5
Chapter 1 Getting Started
DIN
X Series User Manual