Ctp Fast Ethernet And Power Cables; Fast Ethernet Cables; Dc Power Cables; Table 9: Required Cables - Juniper CTP1000 Series Hardware Manual

CTP1000 Series Hardware Guide
Related
Documentation

CTP Fast Ethernet and Power Cables

Fast Ethernet Cables

DC Power Cables

50
Ground wires—We recommend a minimum of 18-AWG ground wire for AC and
DC-powered versions, if applicable.
Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.
Power module wiring—We recommend a minimum of 18-AWG wire for the device with
a dual stud terminal lug with 5/8-inch spacing.
Consider the distance from the connection point and the configuration of the device
when determining the size of wire used.

Table 9: Required Cables

Connection
Management connection between the processor
module and the LAN
Management connection between the processor
module and a management console
Direct connections to interface modules
Cabling the CTP1000 Platform Overview on page 49
Fast Ethernet Cables on page 50
DC Power Cables on page 50
The Ethernet connection is a standard RJ-45 connector. Typically, a straight-through
cable is used to connect to a switch, and a crossover cable is used to connect to a router.
For CTP chassis with DC power options, we recommend 18-AWG power cables.
Port and Cable Used
One 10/100Base-T Ethernet management port
with an RJ-45 connector.
One RS-232 port with a DB-9 connector for
VT100 management access.
Cables vary depending on module.
Copyright © 2015, Juniper Networks, Inc.