Table of Contents
Advertisement
Related
Documentation
CTP1012 Platform
Copyright © 2015, Juniper Networks, Inc.
Figure 6: Wiring a CTP1004 Platform (DC Version)
Do not remove screws or cover.
Use a magnetic screwdriver and
loosen only two to three turns.
Insert wires from bottom.
CTP1002 Platform on page 3
CTP1012 Platform on page 7
The CTP1012 platform is a 1-U high, full-rack wide chassis designed for tabletop or shelf
installation. It can also be installed in a rack with the supplied rack-mounting kit. The
CTP1012 device does not have any removable interface modules, but does use a removable
Type II CompactFlash card and is available in an AC-powered version. It has multiple
cooling fans, and airflow is front to back. See
Figure 7: CTP1012 Platform (AC Version, Front View)
Power switch
Flash drive
HD
P O W E R
The front panel comprises the following components (see
Power LED—Green when power is connected and the power switch is set to the ON
position.
HDD LED—Red when the flash card is in use.
Front power switch—Set to
pressed for four or more seconds.
Removable flash card—The device must be powered off when you insert or remove
the flash card.
USB ports.
The rear panel comprises the following components (See
Power supply—Uses a standard IEC power cord.
Ethernet connection—Provides the 100-Mbps Ethernet connection to the IP network
by means of a local Ethernet switch or router.
Chapter 1: CTP1000 Series Platform Overview
Power switch
Fork terminal connectors
Figure 7 on page 7
USB
ON
position when
1
is briefly pressed. Set to
and
Figure 8 on page
C T P10 12
Figure 7 on page
7):
OFF
when
Figure 8 on page
8):
8.
1
is
7
Advertisement
Table of Contents
Troubleshooting
