CHAPTER 9
Installing the Chassis
Before You Install the CTP1000 Platform
Related
Documentation
Installing the CTP1000 Platform in Freestanding Mode
Copyright © 2015, Juniper Networks, Inc.
Before You Install the CTP1000 Platform on page 47
Installing the CTP1000 Platform in Freestanding Mode on page 47
Installing the CTP1000 Platform in a Rack on page 48
Before installing the platform:
Refer to the platform specifications for the particular CTP model or series.
Have a plan for installing the device that takes into consideration future expansion.
Have the tools and accessories needed to complete the installation.
Read and understand the clearance requirements for the front and back of the chassis
for cable routing and other unit access.
on page 19
for more information.
Read and understand the clearance requirements for the top and bottom of the chassis
to ensure adequate ventilation.
Prepare the equipment racks by measuring and marking space for each device and
plenum you plan to install.
Installing the CTP1000 Platform in Freestanding Mode on page 47
Installing the CTP1000 Platform in a Rack on page 48
When installing the device on a table top or in any other freestanding mode, be sure to
leave enough space around the device for adequate ventilation. Position the chassis with
easy access to the connections that it needs for power, local communications, and remote
communications.
WARNING:
At least two people are required to lift the device. Three people
are required for the heavier CTP platforms.
See"CTP1000 Environmental Requirements"
47