Maintaining Components; Cleaning The Ctp Platform; Required Tools For Maintaining The Ctp Platform - Juniper CTP1000 Series Hardware Manual

Circuit to packet platforms

Hide thumbs Also See for CTP1000 Series:

Table of Contents

CHAPTER 13

Maintaining Components

Documentation

Cleaning the CTP Platform on page 63

Required Tools for Maintaining the CTP Platform on page 63

Storing CTP Modules and Other Components on page 64

Dust is attracted to the area where the air intake vents are located. Clean the area with

a dry cloth every few weeks to prevent excessive accumulation of dust. This cleaning

helps to maintain the efficiency of the cooling system and to prevent damage to electronic

components.

WARNING:

Do not insert any metal object, such as a screwdriver, or place

your hand into an open slot or the backplane when the device is on. Remove

jewelry (including rings, necklaces, and watches) before working on

equipment that is connected to power lines. These actions prevent electric

shock and serious burns.

CAUTION:

When cleaning the device, wear an antistatic wrist strap connected

to an ESD grounding jack. This action helps to protect modules from damage

by electrostatic discharge.

Required Tools for Maintaining the CTP Platform on page 63

Storing CTP Modules and Other Components on page 64

You need the following tools and other items to replace platform components:

Flathead and Phillips screwdrivers

Insulated adjustable wrench

Antistatic wrist strap

Table of Contents

Ctp1002 Ctp1004 Ctp1012