CTP1004 Platform
Figure 3: CTP1004 Platform (AC and DC Version, Front View)
Power switch
HD
P O W E R
Copyright © 2015, Juniper Networks, Inc.
The CTP1004 platform is a 1-U high, full-rack wide chassis designed for tabletop or shelf
installation. It can also be installed in a rack with the supplied rack-mounting kit. The
CTP1004 device does not have any removable interface modules, but does use a
removable Type II CompactFlash card and is available in both AC-powered and
DC-powered versions. It has multiple cooling fans, and airflow is front to back. See
Figure 3 on page
5,
Figure 4 on page
Flash drive
The front panel comprises the following components (see
Power LED—Green when power is connected and the power switch is set to the ON
position.
HDD LED—Red when the flash card is in use.
Front power switch—Set to
pressed for four or more seconds.
Removable flash card—The device must be powered off when you insert or remove
the flash card.
USB ports.
The rear panel comprises the following components (see
Figure 5 on page
6):
Power supply—Uses a standard IEC power cord for the AC version. Uses a 18-AWG
fork terminal connector for the DC version. There is no power redundancy for the DC
version.
Ethernet connection—Provides the 100-Mbps Ethernet connection to the IP network
by means of a local Ethernet switch or router.
Console connection—Provides an asynchronous TTY connection for locally configuring
the CTP device. See
"CTP1000 Console Cable Pinouts" on page 29
information for this connector.
Interface connector—Features a 100-pin connector providing four serial interfaces
when used with the CTP quad cable.
Cable Pinouts" on page 25
USB ports.
Chapter 1: CTP1000 Series Platform Overview
6, and
Figure 5 on page
USB
position when
is briefly pressed. Set to
ON
1
See"CTP1000 Interface Module 100-to-25-Pin
to find pinout information for this connector.
6.
C T P100 4
Figure 3 on page
5):
when
OFF
Figure 4 on page 6
and
to find pinout
is
1
5