Table of Contents
Advertisement
CHAPTER 10
Cabling
Cabling the CTP1000 Platform Overview
Related
Documentation
Required Tools, Wires, and Cables for the CTP1000 Platform
Copyright © 2015, Juniper Networks, Inc.
Cabling the CTP1000 Platform Overview on page 49
Required Tools, Wires, and Cables for the CTP1000 Platform on page 49
CTP Fast Ethernet and Power Cables on page 50
Cabling the CTP platform requires the following main tasks:
Familiarize yourself with the module ports, and ensure that you have the cables and
1.
wires needed to complete each cabling procedure.
Read and understand all safety warnings. (See
2.
on page
33.)
Connect timing ports.
3.
Connect grounding wires to the chassis.
4.
Connect the power cables from the power source to the power supply.
5.
Connect the interface modules to their appropriate network interface.
6.
CTP Cabling Recommendations on page 22
Required Tools, Wires, and Cables for the CTP1000 Platform on page 49
Setting Up Management Access on the CTP1000 Platform on page 57
CTP1000 Console Port Setup on page 57
Cabling your device takes only a few minutes. You need the following items and the
cables listed in
Table 9 on page 50
1/8-inch flathead screwdriver
3/8-inch wrench or 3/8-inch nut-driver
No. 2 Phillips screwdriver
"CTP Safety Guidelines and Warnings"
for proper installation:
49
Advertisement
Table of Contents
Troubleshooting
