Figure 2: Ctp1002 Chassis (Rear View) - Juniper CTP1000 Series Hardware Manual

CTP1000 Series Hardware Guide
Related
Documentation
4
Power LED—Green when power is connected and the power switch is set to the ON
position.
HDD LED—Red when the drive is in use.
Front power switch—Set to
pressed for four or more seconds.
Removable flash drive—The device must be powered off when you insert or remove
the flash drive.
The rear panel comprises the following components (see

Figure 2: CTP1002 Chassis (Rear View)

Ethernet Console
SE-0/0
USB
Power input from the external 12-VDC power supply.
Port 0 and port 1 DB-25 connectors—DB-25 connectors are used for terminating EIA530,
RS-232, V.35, 4WTO, and T1 circuits.
The DB-25 port connector pinout is the same as the quad cables used on the larger
CTP platforms. See"CTP1000 Interface Module 100-to-25-Pin Cable Pinouts" on
page 25 to find pinout information for this connector.
COM 2 console connection—Provides an asynchronous TTY connection for local
configuration of the CTP platform. See
to find pinout information for this connector.
Fast Ethernet connector—Provides the 100-Mbps Ethernet connection to the IP network
by means of a local Ethernet switch or router.
USB port.
CTP1004 Platform on page 5
CTP1012 Platform on page 7
position when is briefly pressed. Set to
ON 1
SE-0/1
External Reference Input
BNC or DB=9
"CTP1000 Console Cable Pinouts" on page 29
when
OFF
Figure 2 on page 4):
Copyright © 2015, Juniper Networks, Inc.
is
1