Garmin G1000 Pilot's Manual page 56

SYSTEM OVERVIEW
TIMERS
The generic timer can be set to count up or down from a specified time (HH:MM:SS). When the countdown
on the timer reaches zero, the digits begin to count up from zero. If the timer is reset before reaching zero
on a countdown, the digits are reset to the initial value. If the timer is counting up when reset, the digits are
zeroed.
Setting the generic timer (PFD):
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to select the TIMER Field (00:00:00).
3) Turn the small FMS Knob to enter the desired time (HH:MM:SS) and press the ENT Key.
4) With the UP/DN Field highlighted, turn the small FMS Knob to select the timer counting direction (UP/DN) and
press the ENT Key.
5) With 'START?' highlighted, press the ENT Key to start the timer. The field changes to 'STOP?'.
6) To stop the timer, press the ENT Key with 'STOP?' highlighted. The field changes to 'RESET?'.
7) To reset the timer, press the ENT Key with 'RESET?' highlighted. The field changes back to 'START?' and the
digits are reset.
8) To remove the window, press the CLR Key or the TMR/REF Softkey.
36
Figure 1-23 AUX – UTILITY Page
Garmin G1000 Pilot's Guide for the Piper PA-32 Saratoga 190-02692-00 Rev. A