Garmin G1000 Pilot's Manual page 323

Displaying original METAR text on the FPL - ACTIVE FLIGHT PLAN Page:
1) Select the FPL - ACTIVE FLIGHT PLAN Page on the MFD.
2) Push the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the desired waypoint. The METAR text will appear in the 'SELECTED
WAYPOINT WEATHER' window below.
4) When finished, push the FMS Knob to remove the cursor or press the FPL Key to exit the Active Flight Plan Page.
To display the METAR legend on the MAP - WEATHER DATA LINK (FIS-B) Page, press the LEGEND
Softkey when METARs are selected for display.
The METAR flag color is determined by the information in the METAR text. The system displays a gray
METAR flag when the METAR text does not contain enough information to determine the METAR category
(e.g., VFR, IFR).
Winds Aloft data inside the Profile View is enabled by default when the Profile View is displayed on the
MAP - NAVIGATION MAP Page. This behavior can be changed on the MAP - NAVIGATION MAP Page.
Enabling/disabling winds aloft data display in Profile View:
1) Select the MAP - NAVIGATION MAP Page.
2) Press the MENU Key.
3) With Map Setup highlighted, press the ENT Key.
4) Turn the small FMS Knob to select the Profile Group and press the ENT Key.
5) Turn the large FMS Knob to select 'Profile Winds'.
6) Turn the small FMS Knob to select 'On' or 'Off'.
7) Push the FMS Knob or CLR Key to return to the MAP - NAVIGATION MAP Page with the changed settings.
190-02692-00 Rev. A
Figure 6-49 METAR Legend
Garmin G1000 Pilot's Guide for the Piper PA-32 Saratoga
HAZARD AVOIDANCE
303