Garmin G1000 Pilot's Manual page 50

SYSTEM OVERVIEW
Exporting a profile to an SD card:
1) Insert the SD card for storing the pilot profile into the top card slot on the MFD.
2) Use the FMS Knob to select the AUX – System Setup Page.
3) If necessary, activate the desired pilot profile to export. Only the currently active pilot profile can be exported.
4) Press the EXPORT Softkey. The system displays the PILOT PROFILE EXPORTING Window.
Or :
a) Press the MENU Key.
b) Turn the FMS Knob to highlight 'Export Pilot Profile' and press the ENT Key.
5) To export the pilot profile using the existing name, press the ENT Key with 'EXPORT' highlighted. To change
the profile file name, turn the large FMS Knob to highlight the SELECT FILE Field, enter the new name with the
large and small FMS Knobs, then press the ENT Key with 'EXPORT' highlighted.
6) If the profile name to be exported is the same as an existing profile file name on the SD card, the system displays
an 'Overwrite existing file? OK or CANCEL' prompt. Press the ENT Key to replace the profile on the SD card with
the profile to be exported, or turn the FMS Knob to highlight 'CANCEL' and press the ENT Key to return to the
PILOT PROFILE EXPORTING Window without exporting the profile.
7) If successful, the EXPORT RESULTS Window displays 'Pilot profile export succeeded.' With 'OK' highlighted,
press the ENT or CLR Keys, or push the FMS Knob to return to the AUX – System Setup Page.
PILOT PROFILE EXPORTING Window; Select
D /t
ate ime
The system obtains the current Universal Coordinated Time (UTC) date and time directly from the GPS
satellite signals (shown on the AUX – GPS Status Page). System time (displayed in the lower right corner
of the PFD) can be displayed in three formats: LOCAL 12hr, LOCAL 24hr, or UTC. Local time is set by
adding/subtracting an offset (hours:minutes) to/from UTC.
30
Profile to Export
Figure 1-19 Pilot Profile Export on AUX – SYSTEM SETUP Page
Garmin G1000 Pilot's Guide for the Piper PA-32 Saratoga
Export Successful
190-02692-00 Rev. A