Garmin G1000 Pilot's Manual page 389

A test pattern of traffic symbols appears during the test, and a 'TRAFFIC' annunciation appears on the
PFDs. At the conclusion of the test, the system issues the voice alert "Traffic System Test". If the test
pattern is displayed and the voice alert is heard, the system has passed the test.
The pilot can select the volume of airspace in which non-threat and proximity traffic is displayed. TA' s
occurring outside of these limits will always be shown.
Changing the altitude range:
1) On the MAP - TRAFFIC MAP Page, select the ALT MODE Softkey.
2) Press one of the following Softkeys:
• ABOVE: Displays non-threat and proximity traffic from 9000 feet above the aircraft to 2700 feet below the
aircraft. Typically used during climb phase of flight.
• NORMAL: Displays non-threat and proximity traffic from 2700 feet above the aircraft to 2700 feet below
the aircraft. Typically used during enroute phase of flight.
• BELOW: Displays non-threat and proximity traffic from 2700 feet above the aircraft to 9000 feet below the
aircraft. Typically used during descent phase of flight.
UNREST (unrestricted): All traffic is displayed from 9900 feet above and 9900 feet below the aircraft.
•
3) To return to the MAP - TRAFFIC MAP Page, press the BACK Softkey.
Or :
190-02692-00 Rev. A
Figure 6-92 MAP - TRAFFIC MAP Page with Test Mode Enabled
Garmin G1000 Pilot's Guide for the Piper PA-32 Saratoga
HAZARD AVOIDANCE
369