Table of Contents
Advertisement
28/263
Bosch Rexroth AG | Tightening Technology
2.6.2
Safety warning sticker
Table 2–1:
Symbol
2.7
Product- and technology-dependent safety instructions for the
Rexroth tightening system 350
2.7.1
Protection against accidental contact with electrical parts
This section only applies to devices and components with voltages above 50 V.
Contacting parts with voltages greater than 50 V can be dangerous to persons and lead to electric shock.
When operating electrical equipment, it is unavoidable that some parts of such equipment conduct dan-
gerous voltage.
High voltage!
Danger to life, risk of injury due to electric shock, or risk of serious injury!
Meaning of the symbols
Meaning
Read all safety instructions and instructions.
Non-compliance with the safety instructions and instructions may cause electric shock, fire and/or
serious injuries.
For EU countries only:
According to the European directive 2002/96/EC electric tools that can no longer be used and ac-
cording to the European directive 2006/66/EC defective or drained accumulators/batteries must
be collected separately and recycled in line with environmental regulations.
DANGER
This device may only be operated, maintained and/or repaired by personnel trained and qualified
to work on or with electrical devices.
Observe the general construction and safety regulations for working with high-voltage systems.
Firmly connect the protective conductor to all electrical devices according to the connection dia-
gram before switching the system on.
Operation, even briefly for measuring or testing purposes, is only permitted if the protective con-
ductor is firmly connected to the components at the intended points.
Disconnect the device from the mains or voltage source before accessing electrical parts with
voltages greater than 50 V. Protect it against being switched on again.
After switching off the power supply, wait 10 seconds for the system to discharge before opening
the housing or starting repair/maintenance work.
For electrical drive and filter components:
After switching off, take the specified discharge time for the respective components into account
before accessing the devices. To eliminate the risk of contact, measure the voltage of the con-
densers before starting work.
Do not touch the electrical connection points of the components when the device is switched on.
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-
3 608 870 A47
Advertisement
Table of Contents
