Table of Contents
Advertisement
3 608 870 A47
9.1.2
Updating the firmware version
To start updating the firmware version, go to the Settings Firmware menu item of the NEXO-OS op-
erating system, see section
When updating to a higher firmware version, the configurations are converted.
As of version 1100 of the Nexo firmware, firmware updates can only be started with a capacity of the bat-
tery pack slide-in module of 25%.
Update to version 1300
As of Nexo firmware version 1300, the operating mode (manual mode or automatic mode) can be select-
ed for the Nexo cordless Wi-Fi nutrunner.
With a firmware update to version 1300, the previous configuration for the mode is transferred to column
A as Automatic operating mode without changes.
In the mode, column B is added for the manual operating mode. This operating mode comprises the fol-
lowing default settings in the start step:
•
•
•
Downgrade
When downgrading from version 1200, the results database is deleted.
Downgrading may be carried out in the following circumstances:
•
•
Following the downgrade, check all configurations, settings and programs and the
MCE factor.
9.2
Starting the program
The browser-based NEXO-OS operating system allows configuring and controlling the Nexo cordless
Wi-Fi nutrunner on any computer desired. The user can simultaneously connect to several operating sys-
tems of different Nexo cordless Wi-Fi nutrunners from one computer, e.g. in different browser windows.
It is also possible connect to the operating system of one Nexo cordless Wi-Fi nutrunner from several
computers.
1.
2.
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-05
Firmware (on page
The source of the ID code for the results output is the cycle counter.
The program selection is enabled.
The job selection is not enabled.
To an older version that was already installed on the nutrunner.
When updating to the previously installed firmware version, the already existing configurations are
applied.
To an older version that was not installed on the nutrunner.
When updating to a lower firmware version, the configurations are not converted
(default configurations are applied).
Open a web browser on your computer.
Enter the IP address of the Nexo cordless Wi-Fi nutrunner in the address bar of the browser.
– When accessing via NX-A programming adapter:
192.168.1.10
– When accessing via WLAN:
IP address entered in the Settings WLAN
This opens the login page of the NEXO-OS operating system.
Tightening Technology | Bosch Rexroth AG 175/263
225).
(see page 230)
menu item.
Advertisement
Table of Contents
