Table of Contents
Advertisement
174/263
Bosch Rexroth AG | Tightening Technology
9.1
General information about the NEXO-OS operating system
The operating system for the Nexo cordless Wi-Fi nutrunner is a web application. On delivery of the Nexo
cordless Wi-Fi nutrunner, it is pre-installed as an integral part of the nutrunner.
9.1.1
Full versions
The functionality of the Nexo cordless Wi-Fi nutrunner is implemented by software.
This software (full version) is created during product development and is pre-installed on delivery of the
Nexo cordless Wi-Fi nutrunner.
Updates for the full version are also provided via the Internet as a part of product development.
Service packs are provided on the Internet at http://www.schraubtechnik.com.
9.1.1.1
Software and firmware version requirements
All components are delivered with installed firmware.
If you use the components in an existing system as a replacement or an extension, you must install the
firmware that is used in the system.
The requirements for the software and firmware versions are currently stored on the Internet at:
http://www.schraubtechnik.com. You can also find instructions for upgrades/downgrades there.
NOTE
Incompatible software and firmware versions may impair the functionality of
the tightening system
From one software and firmware version to the next, changes were made in some of the software
and/or firmware areas; some of these changes are rather comprehensive. This means that, after an
upgrade or downgrade of the system components, the system may sometimes behave differently or
may not be able to run immediately. In some cases, after upgrade/downgrade, the system is not
immediately ready for operation again.
After updating firmware, carry out a functional test to ensure that the tightening system functions
properly.
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-
3 608 870 A47
Advertisement
Table of Contents
