Packing An Optical Ila Chassis Or Component For Shipping; Packing An Optical Ila For Shipping - Juniper PTX3000 Hardware Manual

Packing an Optical ILA Chassis or Component for Shipping

IN THIS SECTION

Packing an Optical ILA for Shipping | 118

If you are returning an optical ILA or component to Juniper Networks for repair or replacement, pack the
item as described in this topic.
Before you pack an optical ILA or component:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See "Prevention of Electrostatic Discharge Damage" on page
Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you do
not have these materials, to learn about approved packing materials (see
on page 112).
Ensure that you have the following parts and tools available:
ESD grounding strap.
Antistatic bag, one for each component.
If you are returning the chassis, an appropriate screwdriver for the mounting screws used on your rack
or cabinet.
Packing an Optical ILA for Shipping
To pack an optical ILA for shipping:
1. Power off the optical ILA and remove the power cables. See
2. Remove the cables that connect the optical ILA to all external devices. See Disconnecting a Fiber-Optic
Cable from an Optical ILA.
3. Remove all field-replaceable units (FRUs) from the device. See:
Removing a Fan Module from an Optical ILA on page 92
Removing a Power Supply from an Optical ILA on page 95
153.
"Contacting Customer Support"
"Powering Off an Optical ILA" on page
118
88.