Connecting The Optical Ila To External Devices; Connecting The Optical Ila To A Management Ethernet Device - Juniper PTX3000 Hardware Manual

Connecting the Optical ILA Grounding Cable | 62
Connecting AC Power to an Optical ILA | 63
Connecting DC Power to an Optical ILA | 66

Connecting the Optical ILA to External Devices

IN THIS SECTION

Connecting the Optical ILA to a Management Ethernet Device | 58

Connecting the Optical ILA to a Management Console | 59
Connecting the Optical ILA to the Network and External Devices | 60
Connecting the Optical ILA to a Management Ethernet Device
You can monitor and manage the optical ILA by using a dedicated management channel. Use the
management port to connect the optical ILA to a network for out-of-band management.
NOTE: You cannot use the management port to perform the initial configuration of the optical
ILA. You must configure the management ports through the console connection before you can
successfully connect to the optical ILA using the management ports. See
Operation" on page
Ensure that you have an appropriate cable available. See
and Pinouts" on page 49.
To connect an optical ILA to a network for out-of-band management (see
1. Connect one end of the cable to the management port (labeled MGMT) on the optical ILA.
2. Connect the other end of the cable to the management network device.
70.
"Optical ILA Modes of
"Optical ILA Management Cable Specifications
Figure 20 on page
58
59):