Configuring The Software On The Optical Ila; Performing Initial Software Configuration For The Optical Ila - Juniper PTX3000 Hardware Manual

Configuring the Software on the Optical ILA

IN THIS SECTION

Performing Initial Software Configuration for the Optical ILA | 69

Optical ILA Modes of Operation | 70
Optical ILA CLI System Commands | 71
Optical ILA CLI show Commands | 72
Optical ILA CLI Configuration Commands | 78
Optical ILA CLI Upgrade Commands | 85
Optical ILA CLI Debug Commands | 86
Performing Initial Software Configuration for the Optical ILA
You must perform the initial configuration of the optical ILA through the console port by using the
command-line interface (CLI).
Before you begin connecting and configuring an optical ILA, set the following parameter values on the
management console or console server:
Baud Rate—115200
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
To setup the IP Address:
1. Connect the console port to a laptop or PC by using the supplied RJ-45 cable and RJ-45 to DB-9
adapter. The console port (labeled CON) is located on the management panel of the optical ILA (see
"Connecting the Optical ILA to a Management Console" on page 59
2. Log in as the root user. Enter the default password root.
for more information).
69