Table 26: Performance Monitoring show Commands (Available in both Auto Mode and Manual
Mode) (continued)
Command
show 15-minute tca-threshold
show 24-hour tca-threshold
show alert-15m
show alert-24h
Optical ILA CLI Configuration Commands
You can use the CLI configuration commands to configure the system parameters and the performance
monitors on the optical ILA in both auto mode and manual mode.
Table 27 on page 79
describes the system configuration commands for the optical ILA. Use these commands
to configure the system parameters.
Description
Displays 15-minute TCA threshold information for these items:
osc-a-tx-power, osc-a-rx-power, osc-a-estimated-fiber-loss, voa-a-attenuation,
edfa-ab-input-power, edfa-ab-output-power, edfa-ab-signal-output-power,
edfa-ab-pump0-current, edfa-ab-pump1-current, edfa-ab-pump0-temperature,
edfa-ab-pump1-temperature, osc-b-tx-power, osc-b-rx-power,
osc-b-estimated-fiber-loss, voa-b-attenuation, edfa-ba-input-power,
edfa-ba-output-power, edfa-ba-signal-output-power, edfa-ba-pump0-current,
edfa-ba-pump1-current, edfa-ba-pump0-temperature,
edfa-ba-pump1-temperature
Displays 24-hour TCA threshold information for these items:
osc-a-tx-power, osc-a-rx-power, osc-a-estimated-fiber-loss, voa-a-attenuation,
edfa-ab-input-power, edfa-ab-output-power, edfa-ab-signal-output-power,
edfa-ab-pump0-current, edfa-ab-pump1-current, edfa-ab-pump0-temperature,
edfa-ab-pump1-temperature, osc-b-tx-power, osc-b-rx-power,
osc-b-estimated-fiber-loss, voa-b-attenuation, edfa-ba-input-power,
edfa-ba-output-power, edfa-ba-signal-output-power, edfa-ba-pump0-current,
edfa-ba-pump1-current, edfa-ba-pump0-temperature,
edfa-ba-pump1-temperature
Displays the 15-minute current alerts.
Displays the 24-hour current alerts.
78