Console Port Connector Pinouts For The Optical Ila - Juniper PTX3000 Hardware Manual

Console Port Connector Pinouts for the Optical ILA

The console port (labeled CON) is an RS-232 serial interface that uses an RJ-45 connector to connect to
a console management device. The default baud rate for the console port is 9600 baud.
Table 21 on page 51 provides the pinout information for the RJ-45 console connector. An RJ-45 cable
and RJ-45 to DB-9 adapter are supplied with the optical ILA.
NOTE: If your laptop or PC does not have a DB-9 plug connector pin and you want to connect
your laptop or PC directly to an optical ILA, use a combination of the RJ-45 cable and RJ-45 to
DB-9 adapter supplied with the device and a USB to DB-9 plug adapter. You must provide the
USB to DB-9 plug adapter.
Table 21: Console Port Connector Pinouts for the Optical ILA
Pin
1
2
3
4
5
6
7
8
RELATED DOCUMENTATION
Management Port LEDs on the Optical ILA | 28
Signal
Reserved
Reserved
TxD Output
Signal Ground
Signal Ground
RxD Input
Reserved
Reserved
Description
Reserved
Data terminal ready/Reserved
Transmit data
Signal ground
Signal ground
Receive data
Reserved
Reserved
51