Connecting Ac Power To An Optical Ila - Juniper PTX3000 Hardware Manual

Figure 23: Connecting a Grounding Cable to the Optical ILA
3. Secure the grounding lug to the protective earthing terminal with the washers and screws.
4. Dress the grounding cable and ensure that it does not touch or block access to other device components
and that it does not drape where people could trip over it.
SEE ALSO
General Safety Guidelines and Warnings | 122

Connecting AC Power to an Optical ILA

Before you begin connecting AC power to an optical ILA:
Read "General Electrical Safety Guidelines and Warnings" on page
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage
(see "Prevention of Electrostatic Discharge Damage" on page
Ensure that you have connected the optical ILA chassis to earth ground.
CAUTION:
attach a cable lug to the grounding and power cables that you supply. A cable with
an incorrectly attached lug can damage the switch (for example, by causing a short
circuit).
Before you connect power to the optical ILA, a licensed electrician must
152.
153).
63