Optical Ila Cli Show Commands - Juniper PTX3000 Hardware Manual

Table 23: System Commands (Available in both Auto Mode and Manual Mode) (continued)
Command
shut
save
ping6 ipv6-address
ping ip-address

Optical ILA CLI show Commands

You can use the following CLI show commands to view, monitor, and troubleshoot the optical ILA in both
auto mode and manual mode.
Table 24 on page 72 describes the system show commands. The output of these commands provides
information about the system parameters.
Table 24: CLI System show Commands (Available in both Auto Mode and Manual Mode)
Command
show cli-time-out
show mfg-info
show (fan | power | mfg) id-eeprom
show temperature
show temperature-threshold
show net
Description
Powers off the optical ILA. If you press the ON button for 5 seconds, the optical ILA
starts up.
CAUTION: The following message is displayed when you enter the shut command.
Shutting down this ILA will affect the traffic in both directions and require someone
to physically turn on the system. Do you want to continue (y/n) [n]:
Saves the configuration to persistent storage.
Pings the destination host IPv6 address.
Pings the destination host IPv4 address.
Description
Displays the number of minutes after which an idle login session is timed
out. The default is 0 minutes, which means the login session is never timed
out.
Displays the main board, power, and fan manufacturing information.
Displays the fan, power, or manufacturing EEPROM information.
Displays the optical ILA board temperature.
Displays the temperature threshold for the optical ILA board.
Displays the system network parameters.
72