Unpacking and Mounting the Optical ILA
IN THIS SECTION
Unpacking the Optical ILA | 54
Mounting an Optical ILA in a Rack or Cabinet | 55
Unpacking the Optical ILA
The optical ILA chassis is a rigid sheet-metal structure that houses the hardware components. The optical
ILA is shipped in a cardboard carton, secured with foam packing material. The carton also contains an
accessory kit and quick start instructions.
CAUTION:
Do not unpack the optical ILA until you are ready to begin installation.
To unpack an optical ILA:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory kit and verify the contents against the inventory of components listed in
Table 22 on page
55.
5. Pull out the packing material holding the optical ILA in place.
6. Verify the chassis components received:
Three fan modules
Two power supplies
7. Save the shipping carton and packing materials in case you need to move or ship the chassis later.
The optical ILA chassis is maximally protected inside the shipping carton.
54