Set Up The Policy Route For The Vpn Tunnel; Figure 62 Vpn > Ipsec Vpn > Vpn Connection > Add; Figure 63 Network > Routing > Policy Route - ZyXEL Communications Unified Security Gateway ZyWALL 1000 User Manual

Chapter 6 Tutorials
Figure 62 VPN > IPSec VPN > VPN Connection > add

6.2.4 Set up the Policy Route for the VPN Tunnel

You should create a new policy route to use the VPN tunnel. This policy route will only use
the existing address objects, so you do not have to create any additional objects first.
1 Click Network > Routing > Policy Route. You want this policy route to have higher
priority than the default policy route for the trunk, so click the Add icon at the top of the
column, not the one next to the existing policy route.
Figure 63 Network > Routing > Policy Route
2 Configure the policy route as shown next. This policy route applies to traffic from ge1.
The source address and destination address must be the same ones represented by the
address objects that you used in the VPN connection. The next-hop is the VPN
connection that you created. Click OK.
134
ZyWALL USG 1000 User's Guide