Chapter 12 Policy and Static Routes
Figure 150 Network > Routing > Policy Route > Edit
The following table describes the labels in this screen.
Table 67 Network > Routing > Policy Route > Edit
LABEL
Configuration
Enable
Description
Criteria
User
Incoming
Interface
Source Address
Destination
Address
Schedule
Service
Next-Hop
230
DESCRIPTION
Select this to activate the policy.
Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Select a user name or user group from which the packets are sent. Select Create
Object to configure a new user account (see
details).
Click Change... to select an interface or VPN tunnel through which the incoming
packets are received.
Select a source IP address object or select Create Object to configure a new one.
Select a destination IP address object or select Create Object to configure a new
one.
Select a schedule or select Create Object to configure a new one (see
on page 527
for details). none means the route is active at all times if enabled.
Select a service or service group from the drop-down list box. Select Create
Object to add a new service. See
information.
Section 34.2.1 on page 506
Section 36.2.1 on page 523
ZyWALL USG 1000 User's Guide
for
Chapter 37
for more