Figure 27 Pptp Encapsulation: Static: Finish - ZyXEL Communications Unified Security Gateway ZyWALL 1000 User Manual

Chapter 4 Wizard Setup
Type the Password associated with the user name.
Select Nailed-Up if you do not want the connection to time out. Otherwise, type the Idle
Timeout in seconds that elapses before the router automatically disconnects from the PPTP
server.
4.3.9.2 PPTP Configuration
Base Interface: This is the identity of the Ethernet interface you configure to connect with a
modem or router.
Type a Base IP Address (static) assigned to you by your ISP.
Type the IP Subnet Mask assigned to you by your ISP (if given).
Server IP: Type the IP address of the PPTP server.
Type a Connection ID or connection name. It must follow the "c:id" and "n:name" format.
For example, C:12 or N:My ISP. This field is optional and depends on the requirements of
your broadband modem or router.
4.3.9.3 WAN IP Address Assignments
You do not configure this section if you selected Auto as the IP Address Assignment in the
previous screen.
WAN Interface: This is the connection type on the interface you are configuring to connect
with your ISP.
Zone: This is the security zone to which this interface and Internet connection will belong.
IP Address: Enter your (static) public IP address.
DNS Server: The Domain Name System (DNS) maps a domain name to an IP address and
vice versa. Enter a DNS server's IP address(es). The ZyWALL uses these (in the order you
specify here) to resolve domain names for VPN, DDNS and the time server.
The ZyWALL applies the configuration settings.

Figure 27 PPTP Encapsulation: Static: Finish

90
ZyWALL USG 1000 User's Guide