Table of Contents
Advertisement
Chapter 44 Service Control
3 The CLI screen displays next.
44.8 Telnet
You can use Telnet to access the ZyWALL's command line interface. Specify which zones
allow Telnet access and from which IP address the access can come.
44.8.1 Configuring Telnet
Click System > TELNET to configure your ZyWALL for remote Telnet access. Use this
screen to specify from which zones Telnet can be used to manage the ZyWALL. You can also
specify from which IP addresses the access can come.
Figure 451 System > Telnet
The following table describes the labels in this screen.
Table 209 System > Telnet
LABEL
Enable
Server Port
Service Control
#
Zone
Address
Action
Add icon
604
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the ZyWALL
CLI using this service.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
This specifies from which computers you can access which ZyWALL zones.
This the index number of the service control rule.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
This displays whether the computer with the IP address specified above can access
the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
Click the Add icon in the heading row to open a screen where you can add a new
rule. Refer to
Table 207 on page 592
Click the Edit icon to go to the screen where you can edit the rule.
Click the Add icon in an entry to add a rule below the current entry.
Click the Delete icon to remove an existing rule. A window display asking you to
confirm that you want to delete the rule. Note that subsequent rules move up by one
when you take this action.
Click the Move to N icon to display a field to type a number for where you want to
put that rule and press [ENTER] to move the rule to the number that you typed.
for information on the fields.
ZyWALL USG 1000 User's Guide
Advertisement
Table of Contents
Troubleshooting
