Table of Contents
Advertisement
Chapter 33 Device HA
Table 152 Device HA > VRRP Group (continued)
LABEL
Apply
Reset
33.5 VRRP Group Add/Edit
The VRRP Group Add/Edit screen allows you to add VRRP groups to the ZyWALL or to
edit the configuration of an existing VRRP group.
• You can only use interfaces that have static IP addresses. In addition, you should set the
static IP address to the IP address of the virtual router.
• You can only enable one VRRP group for each interface.
• You can only have one active VRRP group for each virtual router (VR ID).
To access this screen, go to the VRRP Group summary screen (see
496), and click either the Add icon or an Edit icon.
Figure 367 Device HA > VRRP Group > Edit
The following table describes the labels in this screen.
Table 153 Device HA > VRRP Group > Edit
LABEL
Enable
Name
498
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Select this to make the specified interface part of the virtual router. Clear this to
take the specified interface out of the virtual router.
This field is read-only if you are editing the VRRP group. Type the name of the
VRRP group. This field must be unique in the ZyWALL, but it is not used in the
virtual router. The virtual router uses the VRID. The name can consist of
alphanumeric characters, the underscore, and the dash and may be up to fifteen
characters long.
Section 33.4 on page
ZyWALL USG 1000 User's Guide
Advertisement
Table of Contents
Troubleshooting
