Appendix A Troubleshooting; Using Leds To Diagnose Problems; Power Led; Lan Led - ZyXEL Communications Prestige 645R-A Series User Manual

A.1 Using LEDs to Diagnose Problems
The LEDs are useful aides for finding possible problem causes.

A.1.1 Power LED

The PWR LED on the front panel does not light up.
STEPS
1 Make sure that the Prestige's power adaptor is connected to the Prestige and plugged in to an
appropriate power source. Use only the supplied power adaptor.
2 Check that the Prestige and the power source are both turned on and the Prestige is receiving
sufficient power.
3 Turn the Prestige off and on.
4 If the error persists, you may have a hardware problem. In this case, you should contact your
vendor.

A.1.2 LAN LED

The LAN LED on the front panel does not light up.
STEPS
1 Check the Ethernet cable connections between your Prestige and the computer or hub.
2 Check for faulty Ethernet cables.
3 Make sure your computer's Ethernet card is working properly.
4 If these steps fail to correct the problem, contact your local distributor for assistance.
Troubleshooting
This chapter covers potential problems and the corresponding remedies.

Chart A-1 Troubleshooting Power LED

CORRECTIVE ACTION

Chart A-2 Troubleshooting LAN LED

CORRECTIVE ACTION
Prestige 645R-A Series User's Guide
Appendix A
Troubleshooting
A-1