Figure 14-4 Menu12.1.1 Edit Ip Static Route; Table 14-1 Menu12.1.1 Edit Ip Static Route - ZyXEL Communications Prestige 645R-A Series User Manual

The following table describes the fields for Menu 12.1.1 – Edit IP Static Route Setup.
FIELD
Route #
Route Name
Active
Destination IP Address
IP Subnet Mask
Gateway IP Address
Metric
Static Route Setup
Menu 12.1.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:

Figure 14-4 Menu12.1.1 Edit IP Static Route

Table 14-1 Menu12.1.1 Edit IP Static Route

This is the index number of the static route that you chose in menu 12.1.
Type a descriptive name for this route. This is for identification purpose only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a route to
a single host, use a subnet mask of 255.255.255.255 in the subnet mask field
to force the network number to be identical to the host ID.
Type the subnet mask for this destination. Follow the discussion on IP Subnet
Mask in this manual.
Type the IP address of the gateway. The gateway is an immediate neighbor of
your Prestige that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your Prestige; over WAN,
the gateway must be the IP address of one of the remote nodes.
Metric represents the "cost" of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for directly
connected networks. Type a number that approximates the cost for this link.
The number need not be precise, but it must be between 1 and 15. In practice,
2 or 3 is usually a good number.
Prestige 645R-A Series User's Guide
DESCRIPTION
14-3