This chapter shows you how to configure a remote node.
40.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.x (where x is 1 or 2) - Remote Node Profile,
Menu 11.x.2 - Remote Node Network Layer Options and Menu 11.x.4 - Remote Node
Filter.
40.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown
below).
On a ZyWALL with multiple WAN ports, enter 1 or 2 to open Menu 11.x - Remote Node
Profile and configure the setup for your first or second WAN port. Enter 3 to open Menu 11.3
Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup port
connection (see
On a ZyWALL with a single WAN port, enter 1 to open Menu 11.1 - Remote Node Profile
and configure the setup for your WAN port. Enter 2 to open Menu 11.2 Remote Node Profile
(Backup ISP) and configure the setup for your Dial Backup port connection.
Chapter 40 Remote Node Setup
Remote Node Setup
Chapter 34 on page
510).
ZyWALL 5/35/70 Series User's Guide
C
H A P T E R
4 0
546