Table of Contents
Advertisement
Figure 158 Telecommuters Sharing One VPN Rule Example
Table 108 Telecommuters Sharing One VPN Rule Example
FIELDS
My ZyWALL:
Remote Gateway
Address:
Local Network - Single
IP Address:
Remote Network -
Single IP Address:
19.18.2 Telecommuters Using Unique VPN Rules Example
In this example the telecommuters (A, B and C in the figure) use IPSec routers with domain
names that are mapped to their dynamic WAN IP addresses (use Dynamic DNS to do this).
With aggressive negotiation mode (see
ID types and contents to distinguish between VPN rules. Telecommuters can each use a
separate VPN rule to simultaneously access a ZyWALL at headquarters. They can use
different IPSec parameters. The local IP addresses (or ranges of addresses) of the rules
configured on the ZyWALL at headquarters can overlap. The local IP addresses of the rules
configured on the telecommuters' IPSec routers should not overlap.
See the following table and figure for an example where three telecommuters each use a
different VPN rule for a VPN connection with a ZyWALL located at headquarters. The
ZyWALL at headquarters (HQ in the figure) identifies each incoming SA by its ID type and
content and uses the appropriate VPN rule to establish the VPN connection.
The ZyWALL at headquarters can also initiate VPN connections to the telecommuters since it
can find the telecommuters by resolving their domain names.
Chapter 19 VPN Screens
TELECOMMUTERS
0.0.0.0 (dynamic IP address
assigned by the ISP)
Public static IP address
Telecommuter A: 192.168.2.12
Telecommuter B: 192.168.3.2
Telecommuter C: 192.168.4.15
192.168.1.10
Section 19.8.1 on page
ZyWALL 5/35/70 Series User's Guide
HEADQUARTERS
Public static IP address
0.0.0.0
With this IP address only
the telecommuter can initiate the
IPSec tunnel.
192.168.1.10
Not Applicable
310), the ZyWALL can use the
334
Advertisement
Table of Contents
Troubleshooting
