ZyXEL Communications Internet Security Appliance ZyWALL5UTM 4.0 User Manual page 141

ZyWALL 5/35/70 Series User's Guide
Table 39 WAN: Ethernet Encapsulation (continued)
LABEL
Retype to Confirm Type your password again to make sure that you have entered is correctly.
Login Server IP
Address
Login Server
(Telia Login only)
Relogin
Every(min)
(Telia Login only)
WAN IP Address
Assignment
Get automatically
from ISP
Use Fixed IP
Address
My WAN IP
Address
My WAN IP
Subnet Mask
Gateway IP
Address
Advanced Setup
Enable NAT
(Network Address
Translation)
RIP Direction
141
DESCRIPTION
Type the authentication server IP address here if your ISP gave you one.
This field is not available for Telia Login.
Type the domain name of the Telia login server, for example login1.telia.com.
The Telia server logs the ZyWALL out if the ZyWALL does not log in periodically.
Type the number of minutes from 1 to 59 (30 default) for the ZyWALL to wait
between logins.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Enter the IP subnet mask (if your ISP gave you one) in this field if you selected Use
Fixed IP Address.
Enter the gateway IP address (if your ISP gave you one) in this field if you selected
Use Fixed IP Address.
Network Address Translation (NAT) allows the translation of an Internet protocol
address used within one network (for example a private IP address used in a local
network) to a different IP address known within another network (for example a
public IP address used on the Internet).
Select this check box to enable NAT.
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. The RIP Direction field controls the sending and receiving of
RIP packets.
Choose Both, None, In Only or Out Only.
When set to Both or Out Only, the ZyWALL will broadcast its routing table
periodically.
When set to Both or In Only, the ZyWALL will incorporate RIP information that it
receives.
When set to None, the ZyWALL will not send any RIP packets and will ignore any
RIP packets received.
By default, RIP Direction is set to Both.
Chapter 7 WAN Screens