Figure 46 Port Roles Change Complete - ZyXEL Communications Internet Security Appliance ZyWALL5UTM 4.0 User Manual

Table 29 Bridge Port Roles (continued)
LABEL
WLAN
Wireless Card
Apply
Reset
After you change the LAN/DMZ/WLAN port roles and click Apply, please wait for few
seconds until the following screen appears. Click Return to go back to the Port Roles screen.

Figure 46 Port Roles Change Complete

Chapter 6 Bridge Screens
DESCRIPTION
When you have the wireless card set to WLAN, you can select a port's WLAN
radio button to use the port as part of the WLAN.
The port will use the ZyWALL's WLAN IP address and the MAC address of the
WLAN card.
Note: You must install a wireless card to use the WLAN port role.
See Appendix A on page 660
Select LAN to use the wireless card as part of the LAN.
Select DMZ to use the wireless card as part of the DMZ.
Select WLAN to use the wireless card as part of the WLAN.
The ZyWALL restarts after you change the wireless card setting.
Note: If you set the wireless card to be part of the LAN or DMZ, you
can still use wireless access, but not the WLAN interface in
the firewall. The firewall will treat the wireless card as part of
the LAN or DMZ respectively.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
ZyWALL 5/35/70 Series User's Guide
for how to install a WLAN card.
124