Table 192 Advanced WAN Port Setup: Call Control Parameters
FIELD
Call Control
Dial Timeout (sec)
Retry Count
Retry Interval (sec)
Drop Timeout (sec) Enter a number of seconds for the ZyWALL to wait before dropping the DTR
Call Back Delay
(sec)
34.6 Remote Node Profile (Backup ISP)
On a ZyWALL with multiple WAN ports, enter 3 in Menu 11 - Remote Node Setup to open
Menu 11.3 - Remote Node Profile (Backup ISP) (shown below) and configure the setup for
your Dial Backup port connection.
On a ZyWALL with a single WAN port, enter 2 in Menu 11 - Remote Node Setup to open
Menu 11.2 - Remote Node Profile (Backup ISP) and configure the setup for your Dial
Backup port connection.
Chapter 34 WAN and Dial Backup Setup
DESCRIPTION
Enter a number of seconds for the ZyWALL to keep trying to set up an outgoing
call before timing out (stopping). The ZyWALL times out and stops if it cannot set
up an outgoing call within the timeout value.
Enter a number of times for the ZyWALL to retry a busy or no-answer phone
number before blacklisting the number.
Enter a number of seconds for the ZyWALL to wait before trying another call after
a call has failed. This applies before a phone number is blacklisted.
signal if it does not receive a positive disconnect confirmation.
Enter a number of seconds for the ZyWALL to wait between dropping a callback
request call and dialing the co-responding callback call.
ZyWALL 5/35/70 Series User's Guide
514