Table 287 Wireless Logs; Table 288 Ipsec Logs - ZyXEL Communications Internet Security Appliance ZyWALL5UTM 4.0 User Manual

Table 287 Wireless Logs

LOG MESSAGE
WLAN MAC Filter Fail
WLAN MAC Filter Success
WLAN STA Association
WLAN STA Association List
Full
WLAN STA Association Again The SSID and time of association were updated for an wireless

Table 288 IPSec Logs

LOG MESSAGE
Discard REPLAY packet
Inbound packet
authentication failed
Receive IPSec packet,
but no corresponding
tunnel exists
Rule <%d> idle time out,
disconnect
WAN IP changed to <IP>
Inbound packet
decryption failed
Cannot find outbound SA
for rule <%d>
Rule [%s] sends an echo
request to peer
Rule [%s] receives an
echo reply from peer
Appendix S Log Descriptions
DESCRIPTION
The MAC filter blocked a wireless station from connecting to the
device.
The MAC filter allowed a wireless station to connect to the device.
A wireless station associated with the device.
The maximum number of associated wireless clients has been
reached.
station that was already associated.
DESCRIPTION
The router received and discarded a packet with an incorrect
sequence number.
The router received a packet that has been altered. A third party may
have altered or tampered with the packet.
The router dropped an inbound packet for which SPI could not find a
corresponding phase 2 SA.
The router dropped a connection that had outbound traffic and no
inbound traffic for a certain time period. You can use the "ipsec timer
chk_conn" CI command to set the time period. The default value is 2
minutes.
The router dropped all connections with the "MyIP" configured as
"0.0.0.0" when the WAN IP address changed.
Please check the algorithm configuration.
A packet matches a rule, but there is no phase 2 SA for outbound
traffic.
The device sent a ping packet to check the specified VPN tunnel's
connectivity.
The device received a ping response when checking the specified
VPN tunnel's connectivity.
ZyWALL 5/35/70 Series User's Guide
778