Saving All Projects To Cd-R/Rw Disc - Zoom MRS-1266 Operation Manual

DISC001 DISC001
BURNING BURNING
When the backup is finished, the display shows "SAVE
COMPLETE".
If the project size is larger than the capacity of one CD-R/
RW disc, the disc will be ejected after it has been filled up,
and a message prompting the user to insert the next CD-R/
RW disc appears.
CHANGE CHANGE
DISC002 DISC002
9.
When the above message appears, insert a new
CD-R/RW disc, and press the [ENTER] key.
The backup operation resumes. If more than two discs are
required, the above steps will be repeated. When the backup
is finished, the display indication changes to "SAVE
COMPLETE".
H
INT
When the disc has been ejected, it also possible to abort the
backup operation. To do this, press the [EXIT] key while the
indication "CHANGE DISCxxx" (where xxx is the disc num-
ber) is shown. The indication will change to "SAVE CAN-
CEL?". Press the [ENTER] key to terminate the process.
N
OTE
When a backup spans several discs, the discs must be used
in the same order for restore. Be sure to note the disc number
on the case and label of the disc.
10.
To return to the main screen, press the [EXIT] key
several times.
ZOOM MRS-1266
Disc number

Saving all projects to CD-R/RW disc

You can save all projects on the hard disk to CD-R/RW
media for backup.
If the total size of all projects is larger than the capacity of
one CD-R/RW disc, the backup will automatically extend
over multiple volumes, with lower-numbered projects being
placed on lower-numbered discs.
PRJ 000
Backup
PRJ 001
PRJ 002
PRJ 003
PRJ 004
MRS-1266
N
OTE
Also if all projects were saved in one operation, restoring will
be on a single-project basis.
1.
Insert a CD-R or CD-RW disc into the CD-R/RW
drive.
To back up projects, use a blank CD-R/RW disc or a CD-RW
disc that has been completely erased.
2.
From the main screen, press the [BACK UP] key in
the control section.
The backup menu appears.
BACKUP BACKUP
SAVE SAVE
3.
Use the cursor left/right keys to bring up the
indication " BACKUP ALL SAVE " on the display,
and press the [ENTER] key.
The display shows the space required for the backup of all
projects in MB (megabytes).
Reference [Projects]
PRJ 000
Disc 1
PRJ 001
PRJ 001
Disc 2
PRJ 002
PRJ 002
PRJ 003
Disc 3
PRJ 004
143