Zoom MRS-1266 Operation Manual page 74

Reference [Phrase Looping]
0+(1+2)X 0+(1+2)X
8
9.
When equation input is completed, press the
[ENTER] key.
The following screen appears on the display. This screen lets
you select whether to match phrase playback to the rhythm
section measure.
ADJUST ADJUST
BAR BAR
10.
Turn the dial to select one of the following
methods.
• ADJUST OFF
When you select this setting, the selected phrase is played
continuously, independent of the rhythm song bar lines and
tempo.
1-1 2-1
(measure - beat)
Phrase A
• ADJUST BAR
When you select this setting, phrase playback start is aligned
to the measure start of the rhythm song. If one measure of the
phrase (phrase playback range divided by number of
measures specified by MEAS X parameter) is longer than
one measure of the rhythm song, the phrase is switched
when the number of measures specified by the MEAS X (→
) parameter has played, without waiting for the end of
p.69
the phrase. If one measure of the phrase is shorter than one
measure of the rhythm song, there will be a blank until the
measure where playback switches to the next phrase.
1-1 2-1
(measure - beat)
Phrase A
(MEAS x02)
74
3-1 4-1
Phrase B
3-1 4-1
Phrase B
(MEAS x01)
• ADJUST BAR & LEN
When you select this setting, the phrase length is adjusted so
that the measures of the rhythm song and the phrase are
matched. (Pitch will not change.)
1-1 2-1
(measure - beat)
Phrase A
(MEAS x02)
N
OTE
• When selecting ADJUST BAR or ADJUST BAR & LEN,
verify that the MEAS X parameter for each phrase is set to
a suitable number of measures. If the setting is
inappropriate, the rhythm song and phrase will not
synchronize properly.
• When the stretch/compress rate exceeds a certain range,
the playback may be different from as you desired. In this
case, the display indicates "Out of Range" during the
stretch/compression process.
11.
Press the [ENTER] key.
The indication "CREATE SURE?" appears on the display.
12.
To carry out the phrase loop creation process,
press the [ENTER] key once more.
The phrase loop is created. When the process is completed,
the display reverts to the condition of step 2.
3-1 4-1
Phrase B
(MEAS x01)
ZOOM MRS-1266