Storing A Send/Return Effect Patch; Editing The Name Of A Send/Return Effect Patch - Zoom MRS-1266 Operation Manual

N
OTE
Keep in mind that if you select another patch without first
storing the patch, the edited contents will be lost. If you want
to keep the results of your editing, refer to the following
section.

Storing a send/return effect patch

A patch you edited can be stored in any location of the same
send/return effect. You can also store an existing patch in
another location to create a copy of that patch.
1.
Press the [EFFECT] key, and then press the [EDIT]
key.
The currently selected patch can now be edited. Perform the
necessary steps for editing.
2.
When editing is complete, press the [STORE] key in
the control section.
A screen for specifying the store target location appears on
the display.
Store Store
Standard Standard
3.
Turn the dial to select the store destination patch
number.
4.
Press the [STORE] key once more.
The patch will be stored, and the unit returns to the patch
select screen.
H
INT
• Patches that you have stored are saved on the hard disk
as part of the project.
• Patch data included in an already existing project can be
loaded into the current project (
ZOOM MRS-1266
0 0
→
p. 128).
Editing the name of a send/return
effect patch
This section explains how to edit the name of the patch that
is currently selected for a send/return effect.
1.
Press the [EFFECT] key in the display section, and
then press the [REVERB] key or [CHORUS/DELAY]
key.
If necessary, turn the dial to select the patch whose name you
want to edit.
2.
Press the [EDIT] key, and use the cursor up/down
keys to bring up the indication "PAT NAME".
The name of the selected patch can now be edited. The
character currently selected for editing flashes.
PAT NAME PAT NAME
DeepCho DeepCho
3.
Use the cursor left/right keys to move the flashing
position to the character you want to change, and
turn the dial to select a character.
For information on available characters, refer to page 39.
4.
Repeat step 3 as necessary to complete the new
name.
5.
To confirm the new name, press the [STORE] key in
the control section twice.
The new name is stored, and the unit returns to the patch
selection screen.
Reference [Effects]
127